Miss Cire Aloe Vera wax cartridge is the perfect quick wax solution for those on the go. This roll on aloe vera applicator has been carefully developed for all skin types. It uses a unique formula with vitamins, essential minerals, antioxidants, pigments and high quality ingredients. This allows for a smooth hair removal process, and moisturizes the skin while reducing irritation at the same time. It’s an easy to use and an unbelievably hygienic process. The roll on wax hair removal process is convenient for speed waxing and a time saver for busy waxers.
GLYCERYL ROSINATE, PARAFFINUM LIQUIDUM (MINERAL OIL), COLOPHONIUM (ROSIN), TRIETHYLENE GLYCOL ROSINATE, CERA ALBA (BEESWAX), PROPYLENE GLYCOL DICAPRYLATE/DICAPRATE, ALOE FEROX LEAF JUICE EXTRACT, CI 61565 (GREEN 6).
1-INSERT THE WAX CARTRIDGE: Place the wax cartridge with the Roll-on head up into the Roll-on wax warmer.
2-TURN ON THE UNIT: Turn the switch to “I” located at the front bottom of the unit base. A green light will turn on. Leave the wax warming up for approximately 20 minutes.
3-REMOVE LABEL: Once the wax is liquid remove the plastic label located on the cartridge head.
4-MAKE SURE THE WAX HAS REACHED THE RIGHT TEMPERATURE: Apply the wax directly into a non-woven strip until the wax start to slides smoothly.(use it on a flat and hard surface, such as a table).
5-TEST THE WAX TEMPERATURE: The temperature of the wax will remain constant throughout the day. it is very important to test the wax temperature by applying a small amount on the inside of the wrist before applying directly into the customer.
6-CLEAN THE SKIN: Clean the area to be waxed to remove any residue from the skin such as creams, makeup or sweat. It is recommended to apply our "Pre Depilatory Cooling Gel” until the area is completely dry so the wax adheres better.
7-APPLY THE WAX: Position the Roll-on applicator facing down and slide it over the area to be waxed in the direction of hair growth forming a thin layer.
8-APPLY A NON WOVEN STRIP: Place a non-woven strip on top of the wax layer and press firmly (rubbing) with your hand so the wax adheres well to the strip (release the lower end to be able to hold the strip at the time of pulling).
9-REMOVE THE NON-WOVEN STRIP: Remove the non-woven strip in the opposite direction of hair growth, pulling hard and parallel to the area to be treated. Tighten the skin, especially if there is flaccidity. Avoid pulling vertically.
10-REPEAT THE STEPS: Proceed in the same way throughout the area to be waxed until all the hair in the area is fully removed. You can use the same non-woven strip until it is annoyingly thick to continue.
11-SOOTHE THE WAXED AREA: When finish the treatment, apply our “Post Depilatory Moisturizing Emulsion" to calm and soothe the area, massage evenly until absorbed. It will also help to clean the area of any wax residue that may remain on the skin.
12-TURN OFF THE UNIT: Turn the switch to “O” located at the front bottom of the unit base. A green light will turn off. Disconnect the unit from the electricity outlet.
13-CLEAN THE UNIT: Please make sure that the unit is unplugged from the electricity outlet and that the unit it is completely cooled off. Use a lint “free” soft cloth wet with our "Wax Cleaner” to remove any type of residue on the unit. Never use solvents, aggressive detergents, or any other type of liquids to clean the unit. NEVER EVER SUBMERGE THIS DEVICE UNDER WATER.